How to make resin figurines?
Nov 15, 2023
Leave a message
What is resin materials?
Resin is a convenient material that changes from liquid to solid, making it a modeler's dream. Whether you're making resin figurines for display or to use in a board game, making figurines is very easy. It will take some practice to perfect each step, but you'll be making your own resin figurines in no time. The cast of resin figurines is only half done. Then you can decorate your creation and bring it to life.

Products Description
Make a mold of the figurine model using clay. Create a character prototype using clay. Harden or fire the clay model,alse you can print the models by 3d printer.

Please set it according to the instruction manual of the clay you purchased. Mark the center of the diagram. Draw a line down the center of the shape to divide it in half. This is where the seams in the model are created during casting.
For example, if you have a model, you might want this seam to be on the side of the model instead of at the front and back. Insert the straw into the bottom of the model where you can cut it flat later.
Place the straws so that they line up with the seam line you drew earlier. Mix molding materials according to instructions. Pour enough mixture until the box is almost full, but leave about half an inch of space at the top of the box. Immerse the model in the molding medium up to the pre-marked center line. Dip the model into the center of the formwork.
The straw should be halfway submerged, but not so submerged that it shifts the center line. Wait until the mold hardens and dries. If the mold is sticky, remove it. Repeat the mold creation process for the back part of the mold.
Pour in the remaining liquid, soak the model, and let it dry. Again, pour the resin into the mold by submerging the straw halfway. When the back of the mold becomes sticky, remove the mold.

Wait until the molded part hardens. Fit the two mold halves together so that the cavity forms the negative of the model and the two straw halves fit snugly. Secure the shape together with a rubber band. Mix the resin.
Using a funnel, pour the resin into the mold through the holes in the straw. Let the model dry overnight. Remove the rubber band and open the mold. Be careful not to damage the resin figurines when removing it. Cut a straw shape from the bottom of the model. Paint the figurines and let the paint dry.


