Tips for Assembling Soft Vinyl Designer Toys

Why is it difficult to assemble soft vinyl designer toys?
This problem is primarily due to the fact that soft vinyl barely holds its shape under pressure.

The key to solving this problem is to soften vinyl toy parts to make them easier to work with. Here are a few ways to soften vinyl toy parts:

Tip 1: You can immerse the parts in boiling hot water for about 15-30 seconds and the vinyl will soften and make it easier to work with. Once the vinyl cools, it will return to its original shape. If for some reason you leave the parts in boiling water for longer, don't worry, it won't damage the model.

Tip 2: You can also hold the vinyl sheet under a hair dryer until the vinyl softens. Just hold it about 8 inches from your hair dryer. Do not hold the vinyl directly against a hair dryer as this may deform the vinyl so that it cannot return to its original shape.

Three: There is another method commonly used in factory production, and it is also the most practical method, which is to use a production oven to heat vinyl toy parts, adjust the oven temperature to 35-50 degrees Celsius, and put the vinyl toy parts into it for 3 to Allow 5 minutes to soften and make it easier to assemble.

I hope these methods help you when making vinyl toys.